Nylon 66 Hex Head Set Screws with Dome Nuts & Washers — Pack of 5 Sets
Pickup currently not available
Hex head set screws in nylon 66 — fully threaded, to DIN 933 / ISO 4017 — supplied as a complete fixing set with nylon dome (acorn) nuts and Form A washers. Lightweight, non-conductive and corrosion-proof — the usual choice where a metal fastener would rust, short out, or mark the surface it clamps.
What's in the pack
Every pack contains 5 complete sets:
- 5 hex head nylon 66 set screws
- 10 nylon Form A washers — two per screw
- 5 nylon dome nuts to DIN 1587
Sizes
M4 to M8, in lengths from 10mm to 70mm. Choose bolt size and length above.
Why a hex head
The six-sided head takes a spanner or socket, so you can hold the screw still while the nut goes on — far easier than a screwdriver slot on anything tightening against resistance, and there is no slot to burr or split. Paired with a dome nut it gives a clean finish at both ends.
Why a dome nut
The closed dome covers the thread end completely, removing the sharp edge and giving a finished look. The right choice on exposed work, anywhere hands or clothing pass, and where a protruding thread would snag.
Typical uses
Electrical and electronic assemblies, water and chemical exposure, aquariums and marine trim, model making and signage — anywhere a steel fastener would corrode or conduct. Nylon is softer than metal, so tighten by hand or with light tool pressure only.
Same sets with full hex nuts, wing nuts or flange nuts. Prefer a screwdriver slot? See the slotted cheese-head sets.